Regional standards
Electrical requirements differ between the United States, Canada, the United Kingdom, the European Union, and individual national or local jurisdictions. A globally valid formula does not replace the code adopted at the installation location.
Wire-size boundary
The US mode uses a limited AWG 60°C planning table with approximate conductor resistance. The IEC/UK–EU metric mode selects a common mm² cross-section for resistive voltage drop only and does not reproduce copyrighted ampacity tables. Neither mode implements the full NEC, IEC 60364, BS 7671, DIN VDE, NF C 15-100, CEC, or local amendments.
- It does not fully model insulation rating, terminal rating, ambient temperature, bundling, installation method, raceway fill, reactance, harmonics, motors, continuous loads, fault current, protective-device coordination, or every voltage-drop rule.
- At the July 26, 2026 review, the UK is in the published BS 7671:2018+A3:2024 / A4:2026 transition period through October 15, 2026; users must confirm which edition is accepted for their work and location.
Professional verification
A qualified electrician or electrical engineer must select equipment and conductors, apply required correction factors, verify protection and fault conditions, and inspect the actual installation.
Personal safety
- De-energize and verify before work where legally and technically appropriate.
- Follow equipment instructions, lockout/tagout procedures, permits, and local law.
- Do not work on energized systems unless properly qualified, equipped, and authorized.
Operator and contact
- Hosting
- Cloudflare